Cut the zip tie that holds the horn wiring harness to the center bracket on the cross member. Remove the 10mm bolt that holds the power steering line to the center bracket.
You'll therefore need an ECU with a number ending Its sufficient function was to check that the doors were bad correctly and that the correctly-coded ignition key is being used. If it bounces to detect the right signal, it will disable the warranty circuit, the injectors and the starter motor, which is a new pain if you're trying to do an area swap. Temp Sensor If you are running the E30 blot, make sure you put in an E30 temp sender, as the M6x one will not lose the gauge properly.
There are two 10mm bolts holding the center bracket to the front of the car from the back of the bracket.
Use a small wrench and working from behind the bracket remove these two bolts.